SN Pull-Through Dust Collector

AGET DUSTKOP® SN Series — Pull-Through Cyclone Dust Collectors

The AGET SN Series is the workhorse of industrial cyclone dust collection. The pull-through design means contaminated air enters the cyclone from the lower side inlet, centrifugal force spins the dust out of the airstream and drops it into the storage container below, and cleaned air exits through the upper side outlet. The fan, spark-resistant aluminum, sits on the clean-air side of the cyclone. It never sees the abrasive incoming dust stream, which is why these units run for years with minimal maintenance. Units are fully weatherproofed for indoor or outdoor installation. Storage is in 55-gallon drums (one or two drum arrangements) or in hoppers up to six cubic yards for higher-load applications. AGET offers a complete line of after-filters for use with SN series units when fine dust capture beyond cyclone efficiency is required. Seven standard models cover 400 CFM to over 3,500 CFM. We size the correct model for your application. Inlet size, required airflow, and dust load, and configure the storage arrangement to match your housekeeping requirements.

• Separation Method: Centrifugal — no filter media required for primary separation
• Fan Location: Clean-air side — aluminum spark-resistant wheel never contacts incoming dust
• Installation: Indoor or outdoor — fully weatherproofed housing
• Storage: 55-gallon drum (1 or 2 drum) or hopper arrangements up to 6 cu yd
• After-Filter Option: AGET FILTERKOP or bag-type after-filters available for fine dust capture
• Applications: Woodworking, machining, grinding, buffing, polishing, cutting, chip collection
• Made in USA: AGET Manufacturing, Adrian, MI — since 1938

SN Series — Standard Model Specifications

Model	Motor HP	Inlet Size	Outlet Size	CFM Range	Ship Wt
11SN51	2 HP	6″	9″	400 – 1,200 CFM	320 lbs
20SN31	3 HP	7″, 8″	10″	400 – 1,600 CFM	530 lbs
20SN51	5 HP	7″ – 10″	10″	400 – 2,300 CFM	575 lbs
20SN51-HP	7½ HP	6″ – 8″	8″	400 – 1,800 CFM	600 lbs
30SN90	7½ HP	10″ – 12″	12″	1,200 – 3,200 CFM	710 lbs
30SN100	15 HP	10″ – 12″	12″	2,000 – 3,500 CFM	930 lbs
60SN70	10 HP	12″ – 14″	—	Contact for range	Contact for weight

Specifications from AGET published brochure. Shipping weights shown with standard one-drum (D1) arrangement. Drums not supplied. After-filters and extended storage arrangements available — contact us for complete system sizing.